In the process of processing, stainless steel should adopt all useful methods to prevent the attack of corrosion conditions and causes. In fact, many corrosion condition and inducement to a product's appearance quality was also bad, and probably it is necessary to overcome it, because of its special stainless steel metallographic arrangement and appearance of passivation film, making it in the normally difficult and media have a chemical reaction and corrosion, but not in any condition must not be corrosion. Under the condition of corrosive medium and inducement, stainless steel can also be corroded with slow chemical and electrochemical repercussion of corrosive medium, and under certain conditions, the corrosion rate is fast enough to attack rust appearance, especially pitting and crevice corrosion. The corrosion mechanism of stainless steel is mainly electrochemical corrosion.
The function of the Stainless Steel Sheet is excellent. It is not only smooth and clean, but also has high plasticity, resistance and mechanical strength, corrosion of solution and other medium. It is an extremely rusty alloy steel, but it is not sure that it will not rust. In order to ensure its submission strength, the Stainless Steel Sheet must be treated by annealing, solution treatment and aging treatment before delivery. Select the conditions that should be considered before the stainless steel plate, such as the function and type of the hot cutting machine, and the hardness and gloss of the limited quality requirements. And we should also think about the economic accounting, the most reasonable thickness of stainless steel plate, the most reasonable thickness of stainless steel plate, the strength requirement of the steel during compression, the heat conduction function, the dispersion of pressure, and the standard condition of the platen. If the thickness of the steel plate is not good and the thickness is too large, it is not only required to add the cost of the plate, but also will bring about a certain difficulty. Stainless steel plate processing use remainder. The thickness of the steel plate is not certainly common, but to on the same plate thickness as common standard according to the demand, medium plate, if the demand is too strict, usually anti Zhang Lida, large plate hardness, resistance to mechanical damage function is larger, with longer durability, but the grinding cost is relatively high.